Tag: Operation Guide

Quick Set DCL Regulating Electric Actuator

          Follow the wizard below to quickly set up the control module of the DCL regulated electric actuator. Correct wiring Stroke calibration Setting the automatic status [...]

How do I calibrate (align) the input signal of an actuator?

When there is a deviation between the valve position positioned by the actuator and the input signal when 4~20mA is input (at this time, there is also a deviation between the feedback signal and the input signal), you can [...]

How to configure a switching actuator with bit-firing function?

Mechanical Installation Position Sender Panel Description Commissioning and Setup 1. Mechanical Installation Refer to How to Mount the Actuator to the Valve to install the electric actuator correctly [...].

How to set the regulated motorized valve?

Mounting the actuator to the valve body Adjusting the fully closed mechanical limit Adjusting the fully open mechanical limit Servo controller panel description Setting Operation Output current correction Troubleshooting [...]

How to set the on/off type motorized valve?

Adjustment Micro-adjustable Electrical Limit Adjustment Intermediate Position Model Electrical Limit Adjustment Potentiometer (for C, D models) Adjustment Mechanical Limit Stop Motorized [...]

How do I mount an actuator to a valve?

1、 Rotate the valve manually, check that there is no abnormality, and make the valve in the fully closed position. 2、 Fix the bracket on the valve. 3、 Put one end of the coupling sleeve [...].

How do I set the deadband of an actuator?

By setting the deadband, the actuator can be made to better match the application scenario of PID closed loop control. How to set the deadband of the actuator? There are only 2 steps required: 1. Place the [...]